In this mode you will always connect to the SharpKey by joining its network in the WiFi settings menu of your computer or phone and access the configuration web page using the settings you provided. You can change the network name (SSID), password and IP address range to suit your requirements. This mode is where you have selected Access Point mode via the WiFi Manager menu in the browser configuration. Once the SharpKey has been configured and you selected AP Mode in the WiFi Manager, pressing the WiFi switch for 2-5 seconds will enter Access Point mode. After successful connection, open a web browser and enter in the address bar: - you will now be able to access the SharpKey and configure the WiFi via WiFi Manager. Connect with this network and enter the password: sharpkey. Search on your computer or phone WiFi settings menu for the network: sharpkey. If a bad configuration has been made or you have a network change, press the WiFi switch for 5-10 seconds to load default parameters and enter Access Point mode. Initial factory setup, pressing the WiFi switch for 5-10 seconds will enter WiFi Access Point mode. Initial setup or by forcing default mode. LED Pulses 1 long flash per second when the WiFi key is being pressed for more than 15 seconds and NVS Reset is selected. LED Pulses 1 flash per 0.125 seconds when the WiFi key is being pressed for more than 10 seconds and Bluetooth Pairing mode selected. LED Pulses 1 flash per 0.25 seconds when the WiFi key is being pressed for more than 5 seconds and the SharpKey indicates default parameter Access Point mode selected. LED pulses 1 flash per 0.5 seconds when the WiFi key is being pressed for more than 2 seconds and the SharpKey indicates configured WiFi Client/Access Point mode selected. LED lights briefly on each keyboard key pressed. PS/2 Keyboard or mouse not connected, Bluetooth device not paired. This indicates normal power up and initialisation successful.
0 kommentar(er)
